Information and Advice

Menu

The Banjo Head, Vellum or Skin (As it may Be Called) explained

Banjo Heads, Frosted Top, Mylar, Fiberskyn, Renaissance, Remo, Calf Skin all explained by Eagle Music

For simplification we shall refer to it as the BANJO HEAD. There are many types of Banjo Heads in differing materials and finishes. The most popular modern banjo head is the mylar type plastic head. This head is supplied in different finishes/coatings, each of which gives the banjo a different sound. The banjo head is tensioned like a drum and gives a different sound to the banjo throughout its tension range. In general a slack head is plunky with more depth of tone, whilst a tight head is brighter with a sharper tone. The choice of banjo head and the tension that you apply will influence your banjo’s tone and volume level.

Clear plastic

This uncoated head will give a loud, bright thinner sound but with excellent sustain. A consideration when choosing this head is that you will be able to see directly into the ‘pot’ of your banjo exposing all the inside workings!

Smooth Top – Frosted Bottom

This head is popular with tenor and plectrum banjo players in that the smooth top of the head is not offensive to the brushing of the hand over the head, it is quieter when they strum their banjo and pass their hand or plectrum over the head in the process. The spray coated / frosted bottom gives good bass and more depth of tone than a clear head.

Frosted Top – Smooth Bottom

This head is the most popular with 5-string banjo players and is the first choice for most bluegrass banjos. The spray finished frosted top gives the banjo a crisp bright tone with good depth and distinct note separation, not too much sustain and overtones. The frosting also helps to anchor the bridge in place and gives extra stability to the player that rests one or two fingers of his or her picking hand on the head. Another little tip if you don’t like the feel of the frosted top around the areas where your hand touches the head, and one that I do myself, is to lightly sand the head with a piece of smoothish grade (350) wet and dry.

Fiberskyn

This head has fibres sprayed onto the top of the head, which also gives it a look of a natural skin vellum. This thicker finished head has a quieter, warm and rounder ‘plunkier’ sound that is favoured by old time, clawhammer and frailing players. Unlike a natural vellum, the Fiberskyn head is not affected by damp weather and humidity.

Renaissance

This head has a smooth opaque top with an attractive honey colour. This head will give your banjo a clear bright tone with excellent quality of depth and sustain.

Black

This thicker head gives a mellow tone with lots of depth (bass response) and excellent sustain.

Natural Calf Skin or Goat Skin Vellum

The natural vellum is the traditional banjo head that was the only one available head during the late 1800s and early 1900s. The natural vellum has a warm, mellow full bodied banjo sound, the down side being that it is considerably affected by temperature and humidity! On a warm day the head tightens, on a damp day the head slackens, all this affects the action of your banjo, so you have to consider the following when experimenting with different banjo heads. If you tighten your head it will raise your action because the banjo ‘Bridge’ will move with the head, and likewise if you slacken your banjo head your action will lower.

Products featured in this article

Close

Item(s) added to your compare list